Vajra Techno logoVAJRA TECHNO

Industries Served

Vajra Techno machines components to customer drawings on vertical and horizontal machining centres at Dewas, Madhya Pradesh, in grey cast iron, ductile iron, aluminium, mild steel and SS304/316, and supplies pan-India. Below are the part types quoted in each sector.

This page lists part types that fall inside the confirmed capability, not a customer list. Where a part type is not listed, it may still be within the envelope — send the drawing and it will be assessed against the published capability.

What is machined for pumps and valves?

Pump and valve bodies carry ports and flanged faces on several sides, and the relationship between those faces decides whether the assembly seals. Multi-face castings of this kind are routed to horizontal machining with fourth-axis indexing, so port-to-port position is held in one clamp rather than accumulated across three setups.

What is machined for commercial vehicle and automotive tier-2?

Tier-2 automotive work is repeat-schedule work: the same part, the same drawing revision, month after month, against a delivery calendar. That suits a fixed process plan, a standing fixture and first-article approval that stays valid across the schedule. Batch-to-batch dimensional repeatability matters more than a single best-case part.

Automotive quality system requirements - PPAP submission level, control plan format, run-at-rate and any customer-specific requirement - are agreed at enquiry stage and confirmed in writing before the order is accepted. State the requirement on the RFQ so it is priced into the job rather than raised after the first article.

What is machined for gearbox and transmission?

A gearbox housing lives or dies on bore centre distance and bore-to-bore parallelism across opposing faces. Get the centre distance wrong and the gear mesh is wrong. These features are machined in a single indexed setup so the relationship is held by the rotary axis, not by re-clamping and re-picking a datum between faces.

What is machined for textile machinery?

Textile machinery runs continuously, so rotating components are judged on runout and surface finish rather than on diameter alone. A roller that is on-size but out of runout beats the bearing and marks the yarn. Runout and concentricity are treated as controlled features and checked on every first article.

What is machined for hydraulics and fluid power?

A hydraulic manifold is a solid block of intersecting galleries, and every intersection is both a flow path and a leak path. Cross-drilled galleries are machined from a single datum set with entry position and drill depth both controlled, and every intersection is deburred as a specified operation rather than a cleanup afterthought.

What is machined for electrical equipment?

Motor and switchgear components are judged on concentricity between the bearing seat and the stator bore, and on the flatness of jointing faces. Both are single-datum problems: the bearing seat and the register face are machined from the same datum set so the assembled rotor runs true and the enclosure joint seals.

What sector documentation can you supply?

Material test certificates, lot traceability and per-lot inspection reports are supplied on request. Sector approvals and vendor registrations are confirmed on request rather than claimed on this page — nothing is asserted here that cannot be evidenced. State your documentation requirement on the RFQ and it is confirmed in writing before the order is accepted.

Where are these parts supplied?

All machining is performed at Dewas, Madhya Pradesh, and finished parts are dispatched pan-India by road, on paid or to-pay terms or through a buyer-nominated transporter. GSTIN 23ABBFV9045J1ZY. Send drawings through the RFQ form.